Install Downlights in Areas Where it is Only Possible to Surface Mount
CX1 Extrusion with UFO 14DB Fitting
CX2 Extrusion with UFO 34DB Fitting
CX3 Extrusion with UFO 34DB Fitting
CX4 Extrusion with UFO 34DA Fitting
CX5 Extrusion with Light Points
Cabinet mounting extrusions allow the use of conventional recessed downlight type fittings where it is only possible to surface mount.
The extrusion forms a conduit which conceals the fibre tails until they can be exited fom the end. We normally supply the harness pre-fitted to the extrusion or we can supply the extrusion on its own.
As detailed below, there are five different sizes of extrusion available, from the largest, CX1, to the smallest CX5.
The small CX5 extrusion is unique in that it does not allow for downlights to be fitted to it. Instead it allows for the mounting of fibre tails which shine out through the small holes in the extrusions surface.
- Available extrusion profiles
CX1 extrusion profile
CX2 extrusion profile
CX3 extrusion profile
CX4 extrusion profile
CX5 extrusion profile
We offer a range of three different downlight fittings to fit in these extrusions.
The larger extrusions (CX1 & CX2) can be used with any of these fittings, whilst the smaller extrusions (CX3 & CX4) are suitable for use with the UFO34DA or UFO34DB fittings.
