Install Downlights in Areas Where it is Only Possible to Surface Mount

CX1 Extrusion with UFO 14DB Fitting

CX2 Extrusion with UFO 34DB Fitting

CX3 Extrusion with UFO 34DB Fitting

CX4 Extrusion with UFO 34DA Fitting

CX5 Extrusion with Light Points

Cabinet mounting extrusions allow the use of conventional recessed downlight type fittings where it is only possible to surface mount.

The extrusion forms a conduit which conceals the fiber tails until they can be exited fom the end. We normally supply the harness pre-fitted to the extrusion, or we can supply the extrusion on its own.

As detailed below, there are five different sizes of extrusion available, from the largest, CX1, to the smallest CX5.

The small CX5 extrusion is unique in that it does not allow for downlights to be fitted to it. Instead it allows for the mounting of fiber tails which shine out through the small holes in the extrusion's surface.

• Available extrusion profiles

CX1 extrusion profile

CX2 extrusion profile

CX3 extrusion profile

CX4 extrusion profile

CX5 extrusion profile

We offer a range of three different downlight fittings to fit in these extrusions.

The larger extrusions (CX1 & CX2) can be used with any of these fittings, whilst the smaller extrusions (CX3 & CX4) are suitable for use with the UFO34DA or UFO34DB fittings.